Product description:
The W710G real water leak tester is a pressure seal tester that simulates the product in a water depth of 0-10 meters. It is mainly aimed at the situation where the product with a waterproof and breathable membrane cannot be used for air-tight leak detection.
- 1. Power switch: turn on or off the power of the instrument
- 2. RS485 data interface: used for real-time data transmission, from top to bottom are A, B, GND
- 3. Network socket: for data transmission
- 4. Input and output terminals: instrument start and stop control
- 5. Power socket: connect to DC24V power supply 2A
- 6. RS232 data interface: data transmission, pins 2-RXD, 3-TXD, 5-GND
- 7. T end: test interface, connected to the tested product, R end: standard pressure comparison end
- 8. Air source: 0.5 ~ 0.8MPa stable and clean air source, connected to the inside of the instrument through a filter
- 9. Matching cavity interface: During the fully sealed inspection, select the matching cavity according to the size of the inner cavity of the tested part
Features:
- Differential pressure test method
- Real water test
- Provide integrated solutions, manual testing, automated docking
- Dedicated upper computer software provides customized software services according to customer needs, which can be connected to 1-10 units at the same time
- Provide 16P I/O port, communication port including USB, RS485 for customers to use
- Provide Modbus protocol, up to 10 station numbers can be set
- 0-1bar real water test pressure (meet 0-10 meters waterproof test)
- Absolute pressure unit test
- A variety of leakage units are available: Pa, Pa/s, etc.
- Minimum resolution 1Pa
- High-precision pressure sensor: 0.04%F.S
Test system architecture:

PC software interface:

Schematic diagram of tooling installation and equipment connection:

